Philips 50PFL5907 Bedienungsanleitung PDF herunterladen (Seite 9)

Attaching the base

You must attach the base to the unit to have it as a table top unit.

Be sure the front and rear of the base match the proper direction.

For large screen TVs, at least 2_people are required for these steps.

• Make sure to use a table which can support the weight of this unit and is larger than

this unit

• Make sure the table is in a stable location.

• WlTen attaclTing the base, ensure that"FRONT" with 'arrow" written on the bottom of

the base is downward.

• WlTen attaclTing the base, ensure that all screws are tightly fastened. If the base is not

properly attached, it could cause the unit to fall, resulting in iniuries as well as damage

to the unit,

• To remove the base from this unit, ur_screw the Phillips head screws in step 2,

Be careful not to drop the base when you remove it.

Managing cables

Route your antenna cable and all other cables through the cable

management tie at the back oftheTV,

The holder helps keep your cables tidy and easily manageable,

t Attach the cable management tie as illustrated below.

2 Pass cables through the cable management tie to avoid tansies.

Installing the remote control batteries

t Slide the battery cover offthe back of the remote control.

2 Insert the 2_supplied batteries (AAA, 1,5V). Be sure the + and -

ends of the batteries line up with the markings inside the case,

3 Slide the cover bad( into position,

• Remove the batteries if not using the remote control for an extended period of time.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 66 67

Keine Kommentare

Philips 50PFL5907 Bedienungsanleitung Seite 9