Philips Flat TV Bedienungsanleitung PDF herunterladen (Seite 13)

Tips

Poor Picture •Have you selected the correct TV system in the manual installation menu?

• Is your TV or house aerial located too close to loudspeakers, non-earthed audio

equipment or neon lights, etc.?

• Mountains or high buildings can cause double pictures or ghost images.

Sometimes you can improve the picture quality by changing the direction of the

aerial.

• Is the picture or teletext unrecognisable? Check if you have entered the correct

frequency. See Store TV channels, Manual store,p. 7.

No Picture •Are the supplied cables connected properly ? (The aerial cable to the TV, the

other aerial to your recorder, the VGA cables to the display, the power cables.)

• Is your PC switched on ?

• Do you see a black screen and the indicator in front of the TV lights up green,

this means that the display mode is not supported. Switch your VGA-source to a

correct mode.

• In case of weak or bad signal, consult your dealer.

Digital distortion The low quality of some digital picture material may be the cause of digital image

distortion. In this case select the Soft setting using the Smart picture key ≈ on

the remote control.

No sound • No sound on any channel? Check the volume isn’t at minimum.

• Is the sound interrupted with the mute key ¬?

No solution found Switch your TV off and then on again once. Never attempt to repair a defective

for your picture or TV yourself. Check with your dealer or call a TV technician.

sound problem ?

Have you selected the wrong menu? Press the MENU key again to exit from the

menu.

Remote control • Check if the remote control is in the correct mode.

• If your TV no longer responds to the remote control, the batteries may be dead.

Standby Your TV consumes energy in the standby mode. Energy consumption contributes

to air and water pollution. Power consumption: <3 W.

S-VHS color If S-VHS is disconnected, picture color will become faint.To restore picture color,

becomes faint press the P+ button on the remote control to do a channel up followed by

pressing the P– button to do a channel down.

Tips

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 176 177

Keine Kommentare

Philips Flat TV Bedienungsanleitung Seite 13