Philips 272G5DYEB Bedienungsanleitung PDF herunterladen (Seite 28)

26

7

. Troubleshooting & FAQ

s

7. Troubleshooting & FAQs

7.1 Troubleshooting

This page deals with problems that can be

corrected by a user. If the problem still persists

after you have tried these solutions, contact

Philips customer service representative.

Common Problems

No Picture (Power LED not lit)

v Make sure the power cord is plugged into

the power outlet and into the back of the

monitor.

v First, ensure that the power button on the

front of the monitor is in the OFF position,

then press it to the ON position.

No Picture (Power LED is White)

v Make sure the computer is turned on.

v Make sure the signal cable is properly

connected to your computer.

v Make sure the monitor cable has no bent

pins on the connect side. If yes, repair or

replace the cable.

v The Energy Saving feature may be activated

Screen says

Attention

Check cable connection

v Make sure the monitor cable is properly

connected to your computer. (Also refer to

the Quick Start Guide).

v Check to see if the monitor cable has bent

pins.

v Make sure the computer is turned on.

Visible signs of smoke or sparks

v Do not perform any troubleshooting steps

v Disconnect the monitor from mains power

source immediately for safety

v Contact with Philips customer service

representative immediately.

Imaging Problems

Image is not centered

v Adjust the image position using the “Auto”

function in OSD Main Controls.

Image vibrates on the screen

v Check that the signal cable is properly

securely connected to the graphics board

or PC.

Vertical flicker appears

v Adjust the image using the “Auto” function

in OSD Main Controls.

v Eliminate the vertical bars using the Phase/

Clock of Setup in OSD Main Controls. It is

valid only in VGA mode.

Horizontal flicker appears

v Adjust the image using the “Auto” function

in OSD Main Controls.

Image appears blurred, indistinct or too dark

v Adjust the contrast and brightness on

On-Screen Display.

An "after-image", "burn-in" or "ghost image"

remains after the power has been turned off.

v Uninterrupted display of still or static

images over an extended period may cause

"burn in", also known as "after-imaging "

or "ghost imaging", on your screen. "Burn-

in", "after-imaging", or "ghost imaging" is a

well-known phenomenon in LCD panel

technology. In most cases, the "burned in"

or "after-imaging" or "ghost imaging" will

1 2 ... 23 24 25 26 27 28 29 30 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare