
12 EN
Prepare the remote control
Caution
• Risk of explosion! Keep batteries away from heat,
sunshine or re. Never discard batteries in re.
Forrst-timeuse:
• Remove the protective tab to activate the
remote control battery.
Toreplacetheremotecontrolbattery:
1 Open the battery compartment.
2 Insert one CR2032 battery with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
Note
• Before you press any function button on the remote
control, rst select the correct source with the remote
control instead of the main unit.
• If you are not going to use the remote control for a
long time, remove the battery.
• Point the remote control directly at the IR sensor on
the front of the main speaker for better reception.
Turn on
• Press .
» The SoundSphere DesignLine speakers
switch to the last selected source.
» The source indicator lights up in the
corresponding color.
Switch to sleep mode
• Press again to switch the SoundSphere
DesignLine speakers to sleep mode.
» While the source indicator turns off,
the power indicator lights up red.
Tip
• To switch the SoundSphere DesignLine speakers on
from sleep mode again, you can also press the power
key on the remote control of your TV connected
through HDMI ARC.
• In sleep mode, when you turn on the TV connected
through HDMI (ARC), the SoundSphere DesignLine
speakers wake up automatically.
Toswitchtostandbymode:
• Press and hold for more than three
seconds.
» The power indicator turns off.
Toactivatetheautopowerdownfeature:
• Press down the APD switch on the back of
the main speaker ( : on; : off).
» After staying idle for 30 minutes, the
SoundSphere DesignLine speakers
enter standby mode automatically.
Tip
• To wake up from standby mode, you can press
on the main speaker or the remote control of the
SoundSphere DesignLine speakers.
Kommentare zu diesen Handbüchern