Philips FC6232/02 Bedienungsanleitung PDF herunterladen (Seite 9)

Problem Possible cause Solution

The appliance

suddenly stops

vacuuming, the

appliance beeps,

the vacuum

symbol flashes

and the red

triangle lights up.

The dust container

may be full or the

filter unit may be

dirty. This causes

the motor to

become too hot,

which triggers the

overheat protection

of the motor.

Unplug the appliance and

empty the dust container.

Clean the filter unit. If the

appliance switches off

again when you connect it

to the mains and switch it

on again, replace the EPA

filter. If this does not solve

the issue and the

appliance stops vacuuming

again and again, please

contact the Philips

Consumer Care Centre.

You may have used

the vacuum mode

for more than 30

minutes. This

triggered the

overheat protection

of the motor.

When the motor gets

overheated because the

appliance was used longer

than 30 minutes, you have

to wait 2 hours to let the

appliance cool down.

The suction

power decreased

suddenly.

The dust container

is full, the filter is

dirty or if the

vacuum inlet is

blocked.

Unplug the appliance.

Empty the dust container

and clean the filter. If the

vacuum inlet is dirty, use

the brush to clean it.

The lamp is not

always on or goes

on and off from

time to time.

If you use the

appliance on a dark

surface, the

response time of

the sensor is

longer.

The UV lamp is controlled

by a sensor in the bottom

of the appliance. This

sensor ensures that the

lamp goes out when the

appliance is 5cm off the

surface or the surface is

very dark.

11

English

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 81 82

Kommentare zu diesen Handbüchern

Keine Kommentare